8.2
  Support for Bosch BME280 added
  i2c fixes for ms5611 and delay in i2c probing.
  i2c default speed now 10 kbit/s. Added sanity check when reading i2c-speed from EEPROM.

7.7
  Reports for GPIO pb1 and pb2 added. 

7.6
  Periodprintouts removed

7.5
  Bulk setting: Pin low after (UART) bulk tansfer. 

7.4
  Bulk default settings 0 0

7.3
  Packet bulking framework added. Major work.

7.2
  Bug fix. Multiple report conflict wrt of programmable power 
  A1 (ADC + programmable power). 

  Report A1 is logically controlling the programmable power 3-pin 
  terminal block. It's recommended that A1 only exists in one report. 

7.1
  Sleep mode code clean-up. Also read USB-PWR direct via init.

7.0
  pb2 caommand for TTL control added. MCU type/information in ss command.

6.9
   upgr command fixed. Enabling command line firmware upgrade.

6.8
   v_mcu/BATMON fix for "low ranges" (<2.5V) voltages

6.7
   i2c speed command added

6.6
   v_low fixes 

6.5
   err report added. Also error/status report sent a v_low 

6.4
   Improved i2c errorhandling for SHT2X including CRC check

6.1
    Remote commands sopport added

6.0
    Multiple reports added.

5.9.1
    Atis radio fix for multiple pkts. Low_Voltage thresh added

5.9
    Debug USB-PWR, better report API, BUG fix I2C MCP342X 

5.7
     P0_LST, P1_LST reports added.

5.6
     HEX now prepped w. 0x. Bug in report reading for p1 and
     p1_t fixed.

5.4  SHT2X MS5611 I2C-support added. AH abs. hum, dewpoint
     temp heat index.

5.2
     T_RH read race for hih6130. New format for report
     and debug. "re auto" command added.
 

5.0  New with version and ttl to add relayed networking
     This version is incompatble w. earlier versions.
 
     Added txt field for various use, name, site etc.

4.4  Experimental relay added